Paper stuck to the model question?

Got a question about techniques, materials or other aspects of physically building a model? This is the place to ask.

Moderators: DasPhule, Moderators

Post Reply
User avatar
Tommy8008
Posts: 201
Joined: Mon Oct 22, 2012 5:30 am
Location: United Kingdom

Paper stuck to the model question?

Post by Tommy8008 »

OK, not sure if this is the correct section, if not, then please do move it.

Anyway, I was spraying the inside of my Enterprise - E model and the paint leaked through the windows that I had drilled, I know, arse first, but the paper I lay down, so the paint wouldn't cover the kitchen bench, has become stuck to the outer side of the model, and was wondering the best way to remove it?

I have tried sandpaper, but that is also sanding away the phasers and other details. Also tried a stanley knife, but that is a bit extreme.

Any help would be greatly appreciated.
User avatar
Rocketeer
Posts: 1593
Joined: Fri Jan 18, 2008 4:48 pm
Location: The outskirts of Hobart, WA

Post by Rocketeer »

You might try soaking it in water; that should get the paper off, but the paint that stuck the paper onto the model would still be there. To get that off, I think you'll have to dunk it in some stripper and basically start all over with your paint job. :(

(There are plenty of threads here with advice on stripping paint.)
User avatar
Tommy8008
Posts: 201
Joined: Mon Oct 22, 2012 5:30 am
Location: United Kingdom

Post by Tommy8008 »

I had a feeling that I might have to strip her back.

Thanks for your response.
Post Reply