Rod or tubing?

Got a question about techniques, materials or other aspects of physically building a model? This is the place to ask.

Moderators: DasPhule, Moderators

Post Reply
User avatar
Squall67584
Posts: 905
Joined: Wed Nov 12, 2008 7:32 pm
Location: Just south of Houston

Rod or tubing?

Post by Squall67584 »

I got to thinking about a current project, and need to add some sort of internal support, and was thinking about using something of a 1/16" diameter as an insert. I hit the proverbial wall though, when it comes to whether a 1/16" tube is "stronger" than a 1/16" rod. More or less, I'm preventing a nacelle pylon from warping so it'll just have static weight on it, nothing more than that.
"I never wanted to be anything else but an Engineer." - Montgomery Scott

My Star Wars "fanfic" story series. Sequel in Progress!
Remnants of the Force

Way of the Blaster
kenlilly106
Posts: 1302
Joined: Sun Jan 14, 2007 12:18 am
Location: in the mountains

Post by kenlilly106 »

Post removed due to being tired of this crap

Ken
Last edited by kenlilly106 on Fri Sep 06, 2013 1:22 pm, edited 2 times in total.
User avatar
Rogviler
Posts: 4379
Joined: Thu Jan 15, 2009 7:04 pm
Location: Colorado

Post by Rogviler »

kenlilly106 wrote:Tube are always stronger than a solid rod of the same diameter.
I suspect a long debate is about to happen, but if a rod and tube are the same weight, a tube is stronger. But consider the extreme of a soda can (tube) versus a solid cylinder (rod) of aluminum that's the same diameter... Solid is always going to be stronger for a given diameter, but of course there are weight saving advantages to a tube, which is why they're used in applications such as truck driveshafts (which, when you're 10, can look quite impressive when you lift them over your head).

We're talking about a plastic model kit here, so I'd just throw in some steel rods and be done with it. If we're talking aluminum then either one is going to be pretty bendy at that diameter. Brass would probably be fine, especially if you use it like concrete and rebar, embedding it in epoxy.

-Rog
Last edited by Rogviler on Thu Sep 05, 2013 8:24 pm, edited 1 time in total.
User avatar
scratchy
Posts: 1663
Joined: Fri Feb 06, 2009 8:06 pm
Location: Langley, British Columbia Canada
Contact:

Post by scratchy »

Besides the points in strength as mentioned above, you can also thread wires through the tube for lighting.
User avatar
modelnutz
Posts: 1598
Joined: Fri Aug 12, 2005 11:43 am
Location: behind the big desk

Post by modelnutz »

IMHO....a rod will always be stronger....but...a tube will always be more rigid.

I believe what you are looking for is rigidity..if so..go with the brass tube.
User avatar
Rocketeer
Posts: 1593
Joined: Fri Jan 18, 2008 4:48 pm
Location: The outskirts of Hobart, WA

Post by Rocketeer »

No. A rod will always be stiffer and stronger than a tube of the same diameter.

In your position, with a rod/tube 1/16 in diameter, I'd use solid rod. No appreciable cost difference, and a bit stiffer. And if I wanted it to be stiffer yet, I'd use steel instead of brass.
Post Reply