How to properly decal over glass/matt panels ie refit Ent.

This is the place to get answers about painting, weathering and other aspects of finishing a model.

Moderators: DasPhule, Moderators

Post Reply
Valiant
Posts: 166
Joined: Sun Jan 10, 2010 8:54 pm
Location: Indiana

How to properly decal over glass/matt panels ie refit Ent.

Post by Valiant »

Hey guys! I know the proper way to decal amd seal a model is using a glass amd then matt (or choice) clear spray. But... how would you do this if the paint job itself is a matt/glass pattern. Wouldn't putting an overall gloss and then a matt just negate the paneling detail done?
== Someone needs to tell my wife that starship model building is a good thing... ==
User avatar
Lt. Z0mBe
Posts: 7311
Joined: Thu May 29, 2003 1:46 pm
Location: Balltown Kentucky, by God!
Contact:

Post by Lt. Z0mBe »

I'm not a Trek guy but I think you are describing the alternating matte and gloss panels used to show aztecking on a Trek ship. IF we are talking about the gloss/matte method and no other (color modulation of the basecoat, for instance), method, here's how I would do it:

1.) Lay down primer and then base color over it.
2.) Gloss entire model with Future floor polish.
3.) Lay down decals using Future to set the decals too (it's how I apply decals).
4.) Apply another coat of Future over the decals to really "lock" them in.
5.) Mask off areas to remain gloss coated using low-tack frisket film. Mask off anything else you don't want to be matte-coated.
6.) Apply matte coat in several light coats.

I hope this helps.

Kenny

www.sigmalabsinc.com


Onward, proud eagle, to thee the cloud must yield.
Post Reply