Nice tiny hole punch

Got a question about techniques, materials or other aspects of physically building a model? This is the place to ask.

Moderators: DasPhule, Moderators

Post Reply
Andrew Gorman
Posts: 2697
Joined: Fri Jul 12, 2002 4:56 pm
Location: Escaped from darkest suburbia!

Nice tiny hole punch

Post by Andrew Gorman »

At the local bead store I found a really nice hole punch:
http://www.amazon.com/1-5-2mm-Double-Ho ... hole+punch
It only does round 1.5 mm and 2mm holes, but has a throat 4mm high by 22mm long. This means that you can fit a piece of plastic I-beam in there to punch lightening holes! It works better if you back up the back channel of the I beam with some strip stock (and that gets a nicely punched hole as well. Best of all, it's about 10% of the cost of a Press It and set of hole punch dies from Micro Mark-
http://www.micromark.com/press-it-preci ... ,9309.html
The tool seems nicely made, working parts are hardened, and it works more or less like a bicycle chain tool. Other punch sets work best on, or only on flat stock. I may never have to buy a Katyusha kit again!
Post Reply