The place to discuss all aspects of building models from scratch.
1 post • Page 1 of 1
I have to make 4 copies of an engine from a Buck Rogers Starfighter for my XJ and was wondering. Would it be okay to do a one-piece mold poured in from the top (fuselage side of engine), or a 2 piece mold? I've only just cast small 1 piece molds before (TIE engines) and am apprehensive about a 2-piece for a round shape.
"There is no charge for awesomeness"
Who is online
Users browsing this forum: No registered users and 2 guests