Starship Modeler Discussion Forums

Duplicolor filler primer will make the filling les of a pain . 4 or 5 coats then sand ,then do it all over again till you have it the way you want it.

try a auto paint store

super clean or ez-off oven cleaner

you can use a 555 chip ,one circuit for each strobe rate. I dont know where I found the planes for them but there easy to build. I will try to find the planes.

OdysseySlipways wrote:was it? i forget if it was Norton's or McAfee that use to confuse some of my bmp files as possible virus's a ways back

Norton could not delete it so i did and a full virus scan came up clean. I don't know if it was a virus or not.

I had one for about 5 years then last week norton found it as a virus.

I tried it and it works good, the one problem i had was the blue tape i used did not want to stick when it was cut to a very thin strip . try using reguler masking tape.

I am going to try that and see how it works.

if the plastic is very thin it may melt to much .

I have seen jets mounted on clear rod from the engine, you could paint the flame on the rod.

How big is it?

Since the locating pins broke, you can replace them with stronger pins. Using a pin vise and a small drill bit, drill holes where the old pins used to be, and into the spots where they have broken off. Then at your hobby shop, look in the RC car and plane section. They should have some small diamet...